Splines provide a connection between two shafts or other components that transmit torque and rotation. Splines may be straight sided, tapered, or have an involute form. We produce involute splines as they are much more common. Involute splines have teeth similar to gear teeth except spline teeth are much shorter, and they do not roll.
Involute splines are available in several different pressure angles: 30 degrees, 37.5 degrees, and 45 degrees. The 30-degree splines are by far the most common, so this is what we focus on. Splines are specified as either side fit or major-diameter fit. We make major-diameter fit splines under the guidance of Chinese industrial standards. Teeth are hardened to HRC45-55 and nitriding is available upon request.
Our products are widely used in rolling mills, paper mills, rubber and plastic mills, cranes, pumps, power plants.
Ø Provide the technical design and solutions;
Ø Designing and manufacturing of non-standard shafts and couplings;
Ø Professional technical training and guidance on site according to the contract;
Ø Supply accessories at any time;
Ø Other special technical supports according to client's requirements